تاریخ در دسترس بودن
|مدل محصول||✅ SB-WL-D1210|
|ترمینال خروجی||12 channels|
|نصب و راه اندازی||Wall Mount|
|سایر اطلاعات||✅ Power consumption with load: Less than 10W ✅ Out current in each channel: Max. 12A Total current in channel: Less than 120A✅ Connection: Three phase and five wires|
|گارانتی||18 ماه گارانتی تعویض|
|خدمات پس از فروش||10 سال|
The SB-WL-D1210 is a high performance 12 channel TRIAC dimmer, capable of supplying 10A per channel. The module is able to act as a scene controller, and control lights that demand a high current.
With 12 available channels and a maximum current output per channel of 10A the SB-WL-D1210 can meet a variety of load demands. Each channel can have low, high, and maximum thresholds with a 10 bit dimming accuracy. This ensures stable and graduated dimming.
Resistive loads, inductive loads and LED driver, electronic ballast which support leading edge TRIAC dimming are supported. This means that users can control incandescent lights, halogen lights, and dimmable LED lamps with a single dimming module. If a lamp is not dimmable then it can still be powered on and off.
The status of the CPU is shown via three triple phase LED indicators. These indicators are able to show the power status of phases A, B, and C. The channel output signal status is also represented, by 12 LED indicators.
Protection is of paramount importance in any HDL module. To safeguard the module and the system it is incorporated into short-circuit protection, an over heat sink, ground protection, overload protection, and over heat protection have been included as standard.
When the dimmer has been powered off, it is able to automatically restore the last scene used when it is powered on again. This gives the user a system that remembers their settings, and requires no further control.
■ 10Bitdimming accuracy.
■ 12-channel dimming outputs.
■ LED indicator status.
■ Scene controller.
■ Maximum 12 separate areas, each area has 99 scenes and the maximum running time is 60 minutes.
■ Up to 99 sequences, each sequence has 99 steps and the time interval is 60 minutes for each step, each sequence has 4 running modes of ”forward”, “backward”, “forward and backward” and “random”.
■ Low, high, max threshold for each channel.
■ Each channel has emergency bypass button and debugging bypass button
■ Each scene, area, sequence, channel should mark up.
■ ＊Each channel has current load testing.
■ ＊Each channel has MCB status testing.
■ ＊MCB switch trip warning.
■ ＊Bad lights warning.
■ Communication: HDL Buspro
■ Provides 250mA current(DC24V) for HDL Buspro.
■ Fire protection switch.
■ Short circuit and overload protection, earth protection.
■ Remote programming and management.
■ Device can be restored to previous scene or specified scene, sequence.
Note: functions with * are optional.